Cornelius IDC 2XX Manual de servicio descargar pdf (Pagina 19)

IDC 2XX Service Manual

TROUBLESHOOTING

IMPORTANT: Only qualified personnel should service internal components or electrical wiring.

WARNING: If repairs are to be made to a product system, remove quick disconnects from the

applicable product tank, then relieve the system pressure before proceeding. If repairs are to be

de to the CO

system, stop dispensing, shut off the CO

supply, then relieve the system pressure

before proceeding. If repairs are to be made to the refrigeration system, make sure electrical power

is disconnected from the unit.

Should your unit fail to operate properly, check that there is power to the unit

and that the hopper contains ice. If the

unit does not dispense, check the following chart under the appropriate symptoms to aid in locating the defect.

Dispenser Troubleshooting

Symptom Cause Remedy

Blown fuse or circuit

breaker

Short circuit in electrical wiring Repair Wiring

Inoperable agitator motor (shorted motor) Replace gear motor

Agitator does not turn No power Restore power or plug in unit

Improperly installed upper ice chute assembly

eed switch is not being activated)

Check the upper ice chute assembly for proper

assembly and operation

Inoperable reed switch Replace reed switch

Electrical board driver circuit is defective Replace main control board

Gear motor has open circuit Replace gear motor

Reed switch is not activated Improper

asse

mbly of upper ice chute to lower chute.

Check to make sure tongue of upper chute

engages into the back of the lower chute,

ensure upper chute engages outside the lower

chute, and snap front of chute into place.

Broken wire in the 2-wire harness leading to

the reed

switch

Repair of replace 2-wire harness

Bad connection at main control bo

ard, J3, pins

2 &3

Repair connection or replace 2-wire harness

Ice dispenses

con

tinuously

Ice gate mechanism is stuck in open position

Inspect gasket for proper position. Examine

gate plate to see if it slides freely behind the

lower ice chute.

Stuck or bent ice lever (does not allow gate to

clo

se and open reed switch)

Examine ice dispense lever to see if it is bent.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 25 26 27

Comentarios a estos manuales

Sin comentarios

Cornelius IDC 2XX Manual de servicio Pagina 19

Comentarios a estos manuales

Relacionado con productos y manuales para Máquinas productoras de hielo Cornelius IDC 2XX