
Wilshire Juice Training Manual
© 1999, IMI Cornelius Inc. - 19 -
ATTACHMENTS
The following attachments should be included with this lesson:
Minute Maid Orange Juice 6L Pouch Helpful
Hints guide
SLJ1000-1 Voltage Regulator Board
Installation Instructions
QLT180 Voltage Regulator Board
Installation Instructions
Installation Instructions
Wilshire QLT180 VRB
© 1999, IMI Cornelius Inc.
All Rights Reserved
Do not copy without permission
Form No. TP00910
- 1 -
INSTALLATION INSTRUCTIONS
WILSHIRE QLT180 VOLTAGE REGULATOR BOARD (VRB)
The VRB is located in the
front electrical box directly
behind the lower splash panel.
Remove the drip tray and
splash panel to gain access to
the electrical box.
1.
Disconnect the 5 wire
harnesses from the VRB
and remove the VRB
assembly by loosening
two Phillips screws.
2.
Remove the screw, lock washer, flat washer,
rectangular insulator pad, round insulator, and nut
that secure the regulator heat sink to the VRB
mounting bracket. Separate the VRB from the
bracket by gently squeezing the tips of the white
plastic standoffs.
3.
Reinstall the replacement VRB by reversing the
above procedures.
4.
Attach the five wire harnesses to the VRB as
shown.
IMPORTANT: The regulator mounting hardware must
be installed as shown in order to allow heat dissipation
from the regulator and to prevent the regulator from
grounding. Failure to install the hardware properly may
cause damage to the VRB.
PART NUMBER REFERENCE
45138001.....VRB for McDonald’s QLT
45559 ...........VRB Assembly (includes VRB, bracket,
standoffs and regulator mounting. hardware)
45004 ...........Mounting Kit (regulator mounting. hardware)
ATTACH M EN TS
Comentarios a estos manuales