Cornelius 2000 - Series Manual de instalación descargar pdf (Pagina 23)

638085277

2. Remove motor end bell and stator, if necessary.

3. Check terminals 1 and 3 on overload. No continuity replace overload. Use a volt–ohm meter. See Figures

10 and NO TAG

NOTE: Gear motor and related components can be checked from Pin Connector. See Figures 10 and

NO TAG.

MOTOR CHECK:

The resistance readings on the windings will be between 5 to 25 ohms. A meter capable of these low readings

must be used. The Start Relay cover must be removed.

If no continuity on start or run winding test, replace stator. If continuity on grounded motor test, replace stator.

FIGURE 12. PIN NUMBERS

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 65 66

Sin comentarios

Cornelius 2000 - Series Manual de instalación Pagina 23