Cornelius UC 701 SERIES Manual de servicio descargar pdf (Pagina 21)

UC 701 Series Continuous Flow Icemaker Installation and Service Manual

AUGER AND EXTRUDING HEAD REMOVAL

WARNING:

Disconnect power to the unit before servicing. Follow all lock out/tag out procedures established by the user. Verify all

power is off to the unit before performing any work.

Failure to comply could result in serious injury, death or damage to the equipment.

1. Remove storage container cover and put aside.

2. Turn off water supply to icemaker.

3. After ice has melted from head take hold of the auger nut and lift straight up to disengage from icemaker.

4. When replacing the auger assembly, make certain that both the auger engages the output shaft drive and the

xtruding head ribs engage the evaporator tube. (See Figure 8)

Figure 9. Shaft Seal

INSTALLATION AND SHAFT SEAL REPLACEMENT (See Figure 9)

1. Place shaft seal locator seat and shaft seal mount over

gearmotor output shaft and push down until shaft seal

seat and shaft seal mount rest flush on top of gearmotor.

2. Place rubber coated ceramic seal (important: ceramic face up) over output shaft and push down until seal nest

recess of shaft seal mount. (lubricate rubber on ceramic seal with rubber lubricant).

3. Place shaft seal with carbon face down (spring up) over

output shaft and push (gently) downward until seal

rests on carbon face of the output shaft seal.

4. Place flat washer over output shaft and let rest on the output shaft seal. Push down on the washer compressing

he spring on the output shaft seal. While holding the seals (down) in place slide the E-ring into the groove on

the output shaft.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 29 30

Sin comentarios

Cornelius UC 701 SERIES Manual de servicio Pagina 21