Cornelius 1000-Series Manual de servicio descargar pdf (Pagina 21)

Continuous Flow Icemaker Service Manual

START RELAY

WARNING:

Disconnect power to the unit before servicing. Follow all lock out/tag out procedures established by the user. Verify all

power is off to the unit before performing any work.

Failure to comply could result in serious injury, death or damage to the equipment.

1. Check between “2” and “4” on relay (with relay unplugged). If there is continuity replace the relay, as the relay

contacts should be open.

2. Check between “3” and “4” on relay, if no continuity replace the relay.

Figure 14. Gearmotor Assembly

TO REPLACE GEARMOTOR ASSEMBLY

WARNING:

Disconnect power to the unit before servicing. Follow all lock out/tag out procedures established by the user. Verify all

power is off to the unit before performing any work.

Failure to comply could result in serious injury, death or damage to the equipment.

1. Disconnect the transmission cable from the electrical box.

2. Remove the 4 hex head bolts securing the evaporator to the top of the transmission.

3. Remove the 4 bolt’s holding the transmission and bracket to frame base, while supporting the weight of the

evaporator. Remove the transmission from the unit.

4. When replacing the transmission, it may be necessary to rotate the auger back and forth to align the motor

shaft and auger.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 29 30

Sin comentarios

Cornelius 1000-Series Manual de servicio Pagina 21