Cornelius IDC 2XX Manual de servicio descargar pdf (Pagina 20)

IDC 255 Progate Drive Thru Service Manual

4. Return the inner nozzle to the nozzle and replace the assembly to the valve.

MONTHLY

Clean and sanitize the hopper interior and beverage system, if applicable (see CLEANING

INSTRUCTIONS).

BEVERAGE SYSTEM (IF APPLICABLE)

WARNING: Disconnect Power Before Cleaning! Do no use metal scrapers, sharp objects, or

abrasives on the ice storage hopper, top cover and the agitator disk, as damage may result. Do not

use solvents or other cleaning agents, as they may attack the plastic material.

• Soap solution – Use a mixture of mild detergent and warm (100

F) potable water.

• Sanitizing solution – Dissolve 2 packets (4 oz.) Stera Sheen Green Label into 2 gallons of warm (80-

100

F) water to ensure 200 ppm of available chlorine.

• Cleaning tank – Fill clean, empty tank with a mixture of mild detergent and five (5) gallons of warm

potable water (120

F).

CAUTION: When pouring liquid into the hopper, do not exceed the rate of 1/2 gallon per minute.

Cold Plate

1. Remove splash panel.

2. Remove or move the plastic cold plate cover to expose the cold plate.

3. Locate and remove any debris from the drain trough. Check that the drain holes are not clogged.

4. Pour small amount of soap solution through cold plate openings in hopper.

5. Using a cloth, wash down the surfaces of the cold plate and plastic cover with soap solution.

6. Install and properly position the access covers on the cold plate.

7. Install the splash panel in the reverse order it was removed.

8. Rinse cold plate surface by pouring potable water through hopper openings.

Sanitize syrup lines, B–I–B Systems

1. Remove all the quick disconnects from all the B–I–B containers.

2. Fill a suitable pail or bucket with soap solution.

3. Submerge all disconnects (gas and liquid) in the soap solution and then clean them using a nylon

bristle brush. (Do not use a wire brush). Rinse with clean water.

BOTTOM

PLATE P/N

1903

SNAP FIT CLIP

REAR

TAB

SNAP FIT

CLIP

INNER

NOZZLE

SNAP FIT

CLIP

SNAP FIT

CLIP

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 33 34

Comentarios a estos manuales

Sin comentarios

Cornelius IDC 2XX Manual de servicio Pagina 20

Comentarios a estos manuales

Relacionado con productos y manuales para Máquinas productoras de hielo Cornelius IDC 2XX