Cornelius 322 Especificaciones descargar pdf (Pagina 15)

Xtreme Ice Training Manual

TP00952

October 17, 2005

CLEANING PROCEDURES

Approved ice machine cleaners by brand names:

S Calgon Nickel Safe (green color only)

NOTE: Failure to use approved products will void the warranty.

CAUTION: Ice machine cleaners are acidic-based chemicals. Before beginning any

cleaning of the cuber, the ice in the storage bin or dispenser must be removed.

WARNING: When using any chemical, rubber gloves and eye protection should be worn.

Cleaning Procedure if there is ice on the evaporator plate.

1. Turn the power switch on.

2. Press and hold the Harvest button to start a 4 minute defrost cycle. (Button is located on the control

board see Figure 5).

FILL VALVE

WATER PRESSURE LINE

POWER

NEUTRAL

HOT GAS

WATER PUMP

COMPRESSOR

FAN MOTOR (AIR COOLED)

DUPM VALVE

RH EVAP

SWITCH

LH EVAP

SWITCH

STOCKING

CABLE PLUG

NOTE: CONDENSER SENSOR USED ONLY ON A/C UNITS.

1.8K ohm RESISTER USED ONLY ON W/C AND R/C UNITS.

(WHITE LEAD)

CONDENSER SENSOR SEE NOTE

(BLACK LEAD)

WATER TEMP SENSOR

ERROR

DELAY

CLEAN

HARVEST

UNIT

SELECTION

SWITCH

S3–1

BIN

SWITCHES

TRANSFORMER

BRIDGE

THICKNESS

POT

S3–2

OFF

3 2 1

OFF

MICRO

PROCESSOR

(MANUFACTURING DATE)

3643001

FIGURE 5

NOTE: Condenser sensor used only on A/C units. 1.8k resistor used only in W/C and R/C units.

Single evaporator units must have the proximity connected in the top connection.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 59 60

Comentarios a estos manuales

Sin comentarios

Cornelius 322 Especificaciones Pagina 15

Comentarios a estos manuales

Relacionado con productos y manuales para Máquinas productoras de hielo Cornelius 322