Cornelius ICE FROST Manual del operador descargar pdf (Pagina 14)

Ice Frost Operator’s Manual

Viewing the Bowl Temperature

1. Turn ON the auger on the side that you want to display the bowl temperature (press the “AGER ON/

OFF” button).

2. Press the “PRESS TO SELECT FUNCTION” button until the “Cold” LED is lit. The display will now

show the current bowl temperature in either

F or

C depending on which was selected.

CONSISTENCY ADJUSTMENT

1. To dispense the product, place the cup beneath the tap (Q)

and lower the lever (R) very gently (Figure10).

2. Adjusting the consistency:

To vary the consistency of the ice slush, turn the knob (S)

as shown in Figure 11.

Turning the knob counter-clockwise will increase viscosity

(make the product denser).

Turning the knob clockwise will decrease viscosity (make the

product less dense).

FIGURE 10

ATTENTION: This device only changes the consistency of

the ice slush dispensed, it does not effect the COLD

temperature.

ATTENTION: When the level of the ice slush inside the bowl

is below the minimum, to stop the product becoming too

dense, you must switch off the COLD system (OFF

position), or top up the bowl, following the instructions

given in the previous paragraphs.

An indicator gauge for reference is located on the back of the

unit approximately 6 inches below the adjustment knob.

FIGURE 11

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 33 34

Sin comentarios

Cornelius ICE FROST Manual del operador Pagina 14