Cornelius Xtreme 330 Series Especificaciones descargar pdf (Pagina 10)

630460146

October 27, 2003

DISPENSER INSTALLATION

1. The proper cuber/dispenser installation package should be ordered. This package will include gasket mate-

rial, and hold-down bracket, and bin stat.

2. RTV applications (See Fig. 2 above). If the ice bin is full, new ice will not be able to drop. Instead it blocks

the evaporator curtain open and no additional ice is made. This new ice may start to melt and the resulting

liquid can leak out of the joint between the ice maker and bin. To prevent this problem, seal the joint with

food grade silicon sealant.

3. Install bin thermostat (Part Number 631500074).

AIR-COOLED MODELS

WATER-COOLED MODELS

Electrical Service Line

Manual Disconnect

Switch

STRAIN RELIEF

MUST BE USED

Water Filter

Shut-Off Valve

Dump

Valve

Drain

Tube

Bin Drain

Tube

*Air Gap 4”

“minimum”

Electrical Service Line

Manual Disconnect Switch

Shut-Off Valve

Water Filter

Shut-Off Valve

Condenser Water Inlet

Dump Valve

Drain Tube

*Air Gap 4”

“minimum”

Bin Drain

Tube

Condenser Water

Drain Tube

Strain Relief

must be used

Note: Leave all panels on the cuber until it is in place on the bin.

* An air gap of at least twice the diameter of the water supply inlet plus a minimum of 1” (25 mm) must

exist between the floor drain and drain tube.

Floor Drain

FIG. 4 FIG. 5

PLUMBING CONNECTIONS

1. All plumbing lines and connections must conform to local and

national plumbing codes.

2. Line shut-off valves must be located in supply water lines for cuber and condenser if product is water-

cooled. Water supply to water-cooled condenser must include a stand-pipe to prevent “water

hammer”.

3. Should your local water supply quality require the installation of a water filter system, consult your local dis-

tributor or dealer for proper size required.

4. Water supply pressure must not be lower than 20 PSI (1.37 BAR), nor should it exceed 70 PSI (8.16 BAR).

NOTE: Water filters larger then 5 microns do not give proper protection. Water pressures above 70

PSI (5.44 BAR) will destroy the filter.

DRAIN LINES: Bin and cuber drain lines must never be connected together and must be vented.

NOTE: Always flush inlet water lines 1–2 minutes before connecting to Ice Maker.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 25 26

Comentarios a estos manuales

Sin comentarios

Cornelius Xtreme 330 Series Especificaciones Pagina 10

Comentarios a estos manuales

Relacionado con productos y manuales para Máquinas productoras de hielo Cornelius Xtreme 330 Series